Shimadzu DGU-14A Vacuum Membrane Degasser
The Shimadzu DGU-14A vacuum membrane degasser is ultra-compact and stackable in design and provides you with a fast, efficient way to obtain superior degassing of up to four solvents. For stubborn degassing problems, channels may be connected in series to supply even greater degassing efficiency. The DGU-14A maintains a dissolved oxygen concentration of 2.0 ppm or less at flow rates of up to 3.0 mL/min (1.5 ppm or less at 1.0 mL/min), and can operate at flow rates of up to 20 mL/min per flow line. The DGU-14A has many safety features including a leak sensor to detect mobile phase leakage and signal system shut-down, and built-in self-diagnostics which can signal an alarm upon detection of abnormalities.
Shimadzu LC-10AT Pump
Shimadzu LC-10AT HPLC Pump, offers stable solvent delivery with little flow pulsation, two gradient elution modes are available of low pressure and high pressure, control available from SCL-10A System Controller or on board control, very long life plunger seal, seals and plugers protected against buffer salts, 2 solvents under high pressure and 4 solvents under low pressure.
Shimadzu LC-10AS Pump
The Shimadzu LC-10AS Pump is a solvent delivery unit with a single plunger reciprocating pump, which has been developed for improving accuracy and sensitivity of analysis, for use in a high-performance liquid chromatography.
Shimadzu LC-10AD Pump
The Shimadzu LC-10AD Pump is a solvent delivery module with a double plunger reciprocating pump, which has been developed for improving accuracy and sensitivity, for use in a high-performance liquid chromatograph.
Shimadzu SCL-10A System Controller
The system controller is capable of controlling pump, auto injector, column oven, detector or fraction collector.
Shimadzu SPD-10AVvp UV/VIS Detector
The SPD-10AVvp UV/VIS Detector offers the highest in detector sensitivity and lowest noise level available to ensure reliable peak detection over a wide range.
Shimadzu SPD-M10Avp Diode Array Detector
The Shimadzu SPD-M10Avp Diode Array Detector is in good condition.
Shimadzu HPLC Autosampler
Sample injection time is only 40 seconds for a 10µL injection. When flow line rinsing after injection is included, the unit is ready for the next injection in about 2 minutes. As a result, high throughput repeat analysis is possible, and sample preparations such as dilution and mixing can be performed rapidly. As well as being a multi-purpose autosampler, it is also capable of high speed sample injection. In particular, the time required for sample preparation such as dilution and mixing has been shortened substantially. Furthermore, sample processing capability is greatly enhanced since two 96-well titer plates (standard and deep-well) can be used. Injection repeatability, essential for quantitative analysis, is excellent, producing highly reliable analytical results.
